![]() ![]() There are 3 other terminals on the adapter, +5VUSB - obviously the 5 volt rail, the last 2 are marked PS_ON1 which I am assuming is the power switch on the Xbox and the last is RSENSE which I have no clue what that's about. Question - I have the dc end of the power cord moved into the xbox one adapter in the appropriate terminals, (12V and GND2) all is good so far, however my measured voltage is only 143.4 mv when plugged in. the printer is pretty flexible on its power supply needs but more amps is better. The original adapter was 12 volt 12.5A output, I found a used Xbox one power adapter and its rated for 12 volt 17.9A. Tried to buy a new one from Solidoodle but they are now out of business. I got a roof leak in my garage and the power adapter that came with my 3d printer got soaked and currently is no good. (similar to what you will find on any wall wart) Round with the hole in the middle. I have a Solidoodle 4 3D printer, Its powered by a knock off xbox 360 brick adapter modded from the factory with a standard looking round power plug. I know this may seem like an odd question but here is the history of it.
0 Comments
Leave a Reply. |